7
During the operation of the EWH, the user can adjust the temperature of the water
heating using button «Temp» (Fig. 2, p. 5). The temperature would increase by 1
°
C each
time. Long press increases the data rapidly (5 times/sec.)
«Anti-Bactera» (Fig. 2, p. 3) indication lights up when Anti-Bactera mode is switch-
ing on. Selection of this mode is performed by pressing the button «Setting» (Fig. 2, p.
6), on the control panel. Under this mode the temperature is not adjustable, the system
will enter the heat preservation state after heating to 80
°
C, and return to standard work
after 30 minutes of heat preservation.
«Electronic Anode» (Fig. 2, p. 2) indication lights up when electronic anode is
working normally, and it flashes when it is abnormal.
«Heating/Warming» (Fig. 2, p. 4) indication lights up with red light for normal
heating, green light for keep warming and it flashes under Anti-frost heating. Anti-frost
mode activated when power is on and water temperature in inner tank is lower than 5
°
C
then will stop and standby after heating up to 10
°
C.
If you do not use the EWH in the winter time and there is a possibility of freezing
of the main waterways and the water heater itself, it is recommended to turn off the
power and drain the water from the EWH in order to avoid damage to the inner tank.
Smart mode is activated in the Thermex Home mobile application when the water
heater is controlled using a mobile device via Wi-Fi. In this operation mode EWH can
study and record user’s habits in using hot water and prepare hot water in advance for
the next water cycle (7 days in a cycle). When users do not need hot water, it can main-
tain water at minimum temperature. Thus comfort and saving of energy can be achieved.
This mode is used for those who use hot water on a regular basis.
For control from a mobile device water heater has Wi-Fi function.
1. Install app “Thermex Home” from GooglePlay or AppStore. Create an account.
Before connecting the device to a mobile device, make sure that the device is connected
to the electricity and is within the range of a wireless Wi-Fi network.
2. On water heater panel press and hold button «Power» for 3 seconds when power
is on (Fig. 2, p. 7). Appears Wi-Fi indication (Fig. 2, p. 8).
3. In application “Thermex Home”:
• click Add Device
• from the drop list, select Water Heater
• next follow the instructions of application.
Failures:
• make sure Wi-Fi function is enabled on your mobile device
• make sure you are connected to the Internet
• or contact your provider.
ы
EN