21
Ground
To prevent electrical shock, always plug power lead
into an earthed point.
Water Heater
Electrical Shock Hazard
Do not connect the electrical power to the
appliance until all Remote Controllers have been
connected.
It may result in death or serious injury from
electrical shock.
WARNING
Electrostatic discharge can affect electronic
components.
Take precautions to prevent electrostatic
discharges from personnel or hand tools during
the Water Heater installation and servicing to
protect product’s electronic control.
CAUTION
Power Supply
• The Water Heater is equipped with a 1.5 m cable
with a three pinned earthed plug to be connected
to 230 - 240 VAC at 50 Hz.
The power consumption may be up to
TH17/21ENB series 179 W, TH26ENG series 166
W.
Use an appropriate circuit.
• The Water Heater requires 230-240 VAC 50 Hz in
Australia and New Zealand, weatherproof plug
installed in a protected position adjacent to the
appliance.
• If the power cord is damaged and requires
replacement, use only an original spare part
available from the manufacturer.
• Tie the redundant power cord outside the Water
Heater. Putting the redundant length of cord
inside the Water Heater may cause electrical
interference and faulty operation.
NOTE
• Do not let the power cord contact
the gas piping.
• Do not disconnect the electrical
power when not in use. When the
power is off, the freeze prevention
in the Water Heater will not
operate, resulting in possible
freezing damage.
8. Connecting Electricity
Summary of Contents for TH17ENB5L
Page 28: ......