13
• Protect your hands with gloves and take
caution to not inflict injury.
• Be careful not to hit electrical wiring, gas, or
water piping while drilling holes.
CAUTION
• Installation must conform with all local
building, water or Gas Regulations or AS/NZS
5601.
• The weight of the appliance will be applied
to the wall. If the strength of the wall is not
sufficient, reinforcement must be done to
prevent the transfer of vibration.
• Install the appliance on a vertical wall and
ensure that it is level.
• Insure no additional pressure is applied to the
pipework.
NOTICE
1. Drill a single screw hole, making sure to hit a
stud.
2. Insert and tighten the screw and hang the Water
Heater by the upper wall mounting bracket.
3. Determine the positions for the remaining four
screws (two for the top bracket and two for the
bottom), and remove the Water Heater.
Locaon of Screw Hole
Mounng Bracket
(upper)
Locaon of Screw Hole
4. Drill holes for the remaining four screws.
5. Hang the Water Heater again by the first screw,
and then insert and tighten the remaining four
screws.
6. Take waterproofing measures so that water does
not enter the building from screws mounting
the device.
Anchoring Screw
Do not drop or apply unnecessary force to the
appliance when installing. Internal parts may be
damaged and may become highly dangerous.
WARNING
5. Installation of the Water Heater
5.1 Securing the Water Heater to the
wall
7. Make sure the Water Heater is installed securely
so that it will not fall or move due to vibrations
or earthquakes.
If installation altitude is higher than 600 m, contact
Customer Service to change the altitude settings.
5.2 Elevation Adjustment Above
600 m (TH26ENG series only)
Summary of Contents for TH17ENB5L
Page 28: ......
