11
Installation Instructions:
Step 1:
Step 3:
Step 4:
Step1 : Part Installation
Take out TS-140 Direct heat-sink from the
color box . Pull both ends of the Fan clip and
make them go through holes on the corners
of the heat-sink. (As shown in the picture.)
Repeat for the other fan clip. Leave both fan
clips on the heat-sink body for fan installation
later on . Insert the four black Rubber Tubes
(Noise damping use) into the four indents on
the front of the heat-sink body. Do not remove
them.
Step 3 : Back Plate Cap
Note: When installing on an AMD platform, please first insert the Back Plate Cap into the opening on the
Metal Back plate, make sure you have the Cap facing downwards.
Step 4 : Screw Cylinder Installation
Place the motherboard on top of the Back Plate. See the four Screw Pillars go through the four holes
around the processor socket.Cap the four Screw Pillars with the four Screw Nuts.Make sure the side
with a washer is facing the Back Plate.
Step 2:
Step 2 : Backplate Installation
Choose the platform (AMD) you are in use. Make four
M3L10 Screw Pillars go through the Metal Back Plate
and the Mylar film from bottom towards top. And then
place the Metal Back Plate on the table. Put the four
Washers (for AMD) around the Screw Pillars.
AMD
1
2
3
4
