7
Do not install the unit in a place where there is a chance of flammable gas leaks.
If
there is a gas leak and gas accumulates in the area surrounding the unit, it could cause an
explosion.
Perform the drainage/piping work according to the installation instruction.
If there is a defect in the drainage/piping work, water could leak from the unit and household
goods could get wet and be damaged.
Do not clean the unit when the power is ‘on’.
Always shut ‘off’ the power when cleaning or servicing the unit. If not, it could cause an injury
due to the high speed running fan or an electrical shock.
Do not continue to run the unit when there is something wrong or there is a strange
smell.
The power supply needs to be shut ‘off’ to stop the unit; otherwise this may cause an
electrical shock or fire.
Be cautious when unpacking and installing the product.
Sharp edges could cause injury. Especially watch the edges and the fins on the heat
exchanger of the product.
Always check for gas (refrigerant) leakage after installation or repair of product.
Low refrigerant levels may cause failure of the product.
The installation of the unit must be level and secure.
To avoid vibration and or water leakage
Do not put your fingers or others into the fan, or evaporator.
The
fan runs at high speed, this could cause serious injury.
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external switching device, such as a timer, or
connected to a circuit that is regularly switched on and off by the utility.
This appliance has not been designed for use by persons (including children) with reduced
physical, sensorial or mental faculties or by persons without any experience or knowledge of
heating systems, unless they act under the safety and supervision of a responsible person
or have received prior training concerning the use of the appliance. Children should be
supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualified person in order to avoid a hazard. The means for disconnection must
be incorporated in the fixed wiring and have an air gap contact separation of at least 3mm in
each active(phase)conductors.
