WARNING
WARNING
Read and understand this entire Operating Manual and your
employer’s safety practices before installing, operating, or
servicing the equipment.
While the information contained in this Operating Manual
represents our best judgement, Thermal Dynamics Corporation
assumes no liability for its use.
Econo-Pak 50 Air Plasma Cutting Power Supply
Operating Manual Number 0-2450
Published by:
Thermal Dynamics Corporation
Industrial Park No. 2
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
Copyright 1997 by
Thermal Dynamics Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written
permission of the publisher is prohibited.
The publisher does not assume and hereby disclaims any liability
to any party for any loss or damage caused by any error or
omission in the Econo-Pak 50 Air Plasma Cutting Power Supply
Operating Manual, whether such error results from negligence,
accident, or any other cause.
Printed in the United States of America
September 1, 1998
Summary of Contents for Econo-Pak 50
