Thermal Dynamics cutmaster A60, Service Manual

Page: 130 / 148

CUTMASTER A60
PARTS REPLACEMENT 7-6 Manual 0-4982
5. Remove the fitting from the filter element as-
sembly by inserting a 6 mm hex wrench into
the internal hex fitting and turning it counter
clock-wise (left). Numbers 4 and 5 in the previous
illustration.
6. Disconnect the input line from the filter element
assembly.
7. Remove the filter element assembly through the
rear opening.
NOTE
If replacing or cleaning just the filter element
refer to the following illustration for disas-
sembly.
Art # A-07990
Filter Element
8. Install the new or cleaned assembly by reversing
these procedures.
9. Turn ON the air supply and check for leaks before
reinstalling the cover.
B. Voltage Selection Switch Replacement
Tools required: T20 Torx Driver, 9/16” wrench
1. Remove the Cover per subsection 7.04-A.
2. Disconnect J3 from the Logic PCB
3. Remove retaining nut securing the switch to the
rear panel.
4. Feed the wires and connectors out of the panel
5. Install replacement filter by reversing above
steps.
C. Input Power Cable Replacement
Tools required: T20 Torx Driver, Phillips Head Screw-
driver, Flathead Screwdriver,
1. Remove the Cover per subsection 7.04-A.
2. Disconnect the input cable wires from the W1
contactor terminals and ground lug.
3. Loosen the two screws in the cable strain relief
4. Remove cable through the rear panel.
5. Install replacement Input Power Cable by revers-
ing above steps.
6. Reinstall the power supply cover