47
To access the programming menu the unit must be
in a stopped state. Once the unit is stopped, press
and holding the Display/Program button for 5
continuous seconds. The Program Mode LED will
flash yellow and the display will show “PAS” on the
Process display and "000" on the Set Point display.
The unit is now ready to have the password entered.
From the factory, the password is set to “000”. Use
the Up or Down arrow buttons to increase the
numeric value on the Set Point display until the
correct password value is shown. To enter the
password, press and release the Start button.
If the password is incorrect, there will be a “no” on
the Set Point display and "PAS" on the Process
display. After 5 seconds, the unit will go back to the
password entry mode and display “PAS” on the
Process display and "blanks" on the Set Point
display. If no activity occurs for another 5 seconds,
the controller exits the programming mode and
returns to the Stopped state.
Once in the program menu, use the Display/Program
button to scroll through the different adjustable
parameter as shown in Table 15.
To change an item, press the Display/Program
button until the item code displays in the Process
display. Pressing the Alarm Reset button and
Display/Program button at the same time will
reverse the direction the Display/Program button
indexes through the menu items. Once the desired
menu item code displays in the Process display, use
the Up and Down arrow buttons to adjust the valve
shown in the Set Point display until the desired value
shows. Press the Start button to enter the display
value. Press the Stop button to cancel and revert to
the previously value.
There is a Master Reset function to restore all User
menu parameters to their factory default values. To
initiate a Master Reset the unit must be in a stopped
state. Once the unit stops, press and hold the Alarm
Silence/Reset button and Stop button
simultaneously for 10 consecutive seconds until
“PRG” shows on the Set Point display and "RSt"
shows on the Process display. To confirm a Master
Reset is desired, press and release the Start button
and the system will perform a Master Reset and
reboot. The Master Reset aborts after the “PRG”
shows on the Set Point display and “RSt” shows on
the Process display by turn the control power off or
taking no action for 10 consecutive seconds.
