Thermal Arc 000 Pro K, Owner'S Manual

Page: 14 / 33

15
11. Remote AMPERAGE / VOLTAGE Switch – Allows
remote amperage/voltage device operation through
the 14 pin receptacle.
12. Process Selector switch : CC/CV – Allows the
operator to select the CC (Constant Current) process
or CV (Constant voltage) process.
13. Remote Contactor switch – Allows for the output
contactor to be controlled through the 14 pin
receptacle. When in the Panel position welding
output is present at the output terminal when the
engine is running. When in Remote position output is
controlled through a 14 pin remote device.
14. Arc Control – The Arc Control is use in the SMAW
mode only. Rotate the control clockwise to increase
the short circuit current available to control the
welding arc.
15. 14 Pin receptacle - Used for remote Contactor,
amperage control, and wire feeder control.
16. Serial number.
17. Welding Receptacle: Electrode-Positive output
welding connection for CC (Constant Current) and
CV (Constant Voltage).
18. Choke – Pull knob out engges Choke. Push knob in
for normal operation.
19. 24V AC 10A Circuit breaker – Push to reset.
Controls 24V power source for wire feeders.
Controlled through the 14 pin receptacle.
20. Hour meter - Monitors Time in hours when the
engine is on.
21. Fuel Gauge – Monitors fuel level
22. START button – Used to start the engine. Set the
ON/OFF switch to ON, push START button to the
start the engine. When engine starts release button
23. Engine ON/OFF switch - Place in the ON position to
operate generator. Use the START button to start the
engine. To shut off engine place switch in stop
position.
24. Engine Min/Max R.P.M. switch
25. 13A Circuit breaker - 3 poles circuit breaker controls
460V three phase power source.
26. 460V Output - Access for three phase 460V 60 Hz
connections. Connect Line1, 2 and 3 to the output
side of the circuit breaker and the ground to the bolt
mounted beside the circuit breaker.
2.05 Dimensions and Weight
Height 710mm 27.9”
Width 530mm 20.86”
Length 1080mm 42.52”
A 15mm .59”
B 1050mm 41.34”
C 34.5mm 1.36”
D 424mm 16.69”
E 10.5mm Dia. .41” Dia.
Weight 245 Kg 539.5 lb
2.06 Maximum Welding
Generator Operating Angles
Do not exceed operating angles while running or engine
damage will occur.
The operating angle is a maximum of 25 degrees.
GENERAL INFORMATION