Thermadyne Thermal Dynamics PAK MASTER 50XL, Service Manual

Page: 18 / 74

DESCRIPTION 12 Manual 0-2587
10. Overall Dimensions
18.9" (480 mm) High x 13" (330 mm) Wide x 23.5" (597
mm) Long
Overall dimensions are with handle, lead wrap
bracket, and Gas Requlator/Filter Assembly installed.
B. Gas Regulator/Filter Assembly
Specifications
The following specifications apply to the Gas Regulator/
Filter Assembly only:
1. Gas regulator maximum gauge pressure
160 psi (11 BAR or 11.03 kPa)
2. Maximum input gas pressure
125 psi (8.6 BAR or 861 kPa)
3. Filter
Coalescent type filter
3.04 Power Supply Options and
Accessories
NOTE
Refer to Section 6, Parts Lists, for part numbers
and ordering information.
The following are accessories that are available for this
power supply:
A. Primary Input Power Cable
An optional 220V, single phase, six foot primary in-
put power cable with plug.
B. Two Stage Air Line Filter
An optional two stage air line filter is available. The
filter will remove moisture and contaminants from the
air stream when using compressed air. The filter is
capable of filtering to at least 5 microns. The filter
assembly is pre-assembled at the factory and need
only be attached to the power supply.
C. High Pressure Regulators
High pressure regulators are available for air and ni-
trogen. The regulators are used to set the proper pres-
sure for the type gas being used.
D. Smart Cart
Steel cart on easy rolling 10" pneumatic tires to pro-
vide maximum mobility for the power supply. Handle
is 3/4" tubing with hooks for storage of torch leads.
A tie down strap is also included.
E. 575V Transformer
This step-down transformer allows the power sup-
ply to operate with 575 VAC three-phase input power.
F. Interface Cable
NOTE
This accessory can be used only with the PCM-28
Torches.
The interface cable is available in two lengths, 25 ft
(7.6 m) and 50 ft (15.2 m). The cable is used to inter-
face the power supply with an auxiliary control de-
vice to provide OK-To-Move and ON/OFF signals.