Thermador T24UW905LP, Use & Care Manual

Page: 11 / 40

Page |11
Troubleshooting
Be sure to check these items first:

Is there a power outage in the area?

Is the household fuse blown or the circuit breaker tripped?

Is the appliance properly connected to the electrical supply?
Many problems can be resolved without the need for a service call. See the following list as a reference of possible
solutions of simple problems.
Symptom Possible Cause Potential Remedy
Appliance is not cooling. Appliance has been switched off.
Check display to make sure the unit is not
switched off. If display reads “OFF”, Press and
hold for 3 seconds the ON/OFF Button
The compressor is constantly
running or running too much.
Appliance opened frequently.
Do not open the appliance
unnecessarily.
The ventilation openings have been
covered.
Remove obstacles at the ventilation openings
located at the base of the unit and in the
refrigerator interiors.
A large amount of product, or warm
product was placed into the appliance.
The compressor will run more than
normal until the product cools. The
more
that is added, the longer the motor will
run.
Excessively warm environment.
Avoid placing the unit in direct sunlight, or near
a heat source. If the appliance is in an unusually
warm environment, the compressor will run
more.
Door gasket is not sealing.
Inspect the condition of the gasket. If
damaged, cold air can escape the cabinet
and cause the compressor to run more than
normal.
Products and beverages in the unit are
too cold.
Temperature has been set too low.
Increase the temperature. See “ Setting the
temperature ”.
Product placed too close to ventilation
holes. Rearrange the bottles, so that nothing
obstructs the interior ventilation holes.
The interior light (LED) does not work. The unit is set to Sabbath mode.
Disengage Sabbath mode. See
“ Getting to know your appliance ” section.
There are unpleasant odors coming from
the appliance.
Some bottles may not be correctly
closed or the content of some bottle
may be spilled.
Clean the appliance. Be sure all the bottles
are correctly closed.
(See chapter “ Odors ”).