Service Manual for Thermador Pro Grand Dual Fuel Ranges:
PRD304EG,
PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG
58300000157422_ARA_EN_A
Page 88 of 95
4.7.7 Bake Element Components – Removal & Replacement
(Small Oven)
This procedure is for the small oven of 48-inch ranges.
Bake element components are accessible from the front of the range.
Be sure to check QuickFinder for relevant information, documentation,
and correct part numbers when replacing any of these components.
Sharp Components
Wear gloves when handling bake element components, as they may
have sharp edges
1. Follow all safety precautions and steps in
page
2. Remove oven doors (see
Oven Door Removal, Installation,
3. Remove all the oven racks.
4. Remove the kick panel (see Figure 171 and
page
).
5. Using a flashlight, and wearing gloves, reach through the gap
under the oven, and detach the two wire connectors behind the
bake element tray (see Figure 171 and Figure 172, page 86).
NOTE:
The wire connectors may be a bit tight to remove.
Figure 177: Bottom Cover
1
Screw locations (2) on bottom cover
6. Remove and retain the two screws on the bottom cover that
secure it to the bake element tray, and then remove the bottom
cover (see Figure 177.and Figure 178).
Figure 178: Screw Locations on the Bake Element Tray
1
Screw locations (2) on the bake element tray
7. Remove and retain the two screws securing the element onto the
bake element tray, and then remove the element (see Figure 179).
Figure 179: Element
1
Screw locations (2) securing element to element tray
8. Replace the element if needed.
