THERMACUT EX-TRAFIRE 40SD, Operator'S Manual

Page: 29 / 72

EX-TRAFIRE
®
40SD
Operator Manual, Revision T-15 3-29
5� The hand torch clamped in the cutting guide can be used alone or with a radius bar�
If you don’t want use the radius bar, lock the cutting guide in a fixed position by using of the
screw with hexagonal head so that the wheels of the cutting guide point in the same direction
as the torch handle - see picture below� Now the torch with the cutting guide is ready to cut�
Tighten the screw with
hexagonal head with
the hexagonal wrench�
6� If you want use the radius bar, make sure the screw with hexagonal head isn’t tightened so
that the cutting guide can rotate freely�
7� Screw in the radius bar into the threaded hole in the cutting guide�
* Lengths of bars are 250 mm or 400 mm�
Screw with
hexagonal head
Radius bar