Thermablaster WDFT060-VF-IR, Owner'S Manual, Page: 7 / 33

- 7 -
3. Preparing for installation
Before beginning assembly or operation of the product, make sure all parts are present. Compare parts
with package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Before installing heater, make sure you have the items listed below:
Figure 1 - Vent-Free Gas Heater Infrared
UNPACKING
1. Remove heater from carton.
2. Remove all protective packaging applied to heater for shipping
3. Check heater for any shipping damage. If heater is damaged, promptly inform dealer where you bought
heater.
4. Remove thread protective cup on the gas inlet pipe underneath the heater.
5. Install a D size (IEC R20 or LR20) 1.5 V battery (maybe not available in the packing depends on your
dealer). Be sure battery has full capacity and must be removed if the heater is not in use for an
extended period.
Fig 2 - Heater Bottom
Control knob
Plaque plates
Grill
Igniter knob
Thermostat knob
Igniter knob
WDFT/WLT/WNT250-VF-IR
WDFT/WLT/WNT60-VF-IR
WDFT/WLT/WNT100-VF-IR
Battery Pack
Thread
protective
cap