CARE AND CLEANING
Any piece of equipment works better and lasts longer when properly maintained. Cooking equipment is no
exception. Your THERMA-TEK appliance must be kept clean during the workday and thoroughly cleaned
at the end of the day.
STOCK POT
•
Remove top grate and wash thoroughly with hot soapy water. Be sure to clean burner ports by using
a piece of wire
•
Make sure air shutter openings are clear of any debris.
•
Make sure pilots are clean and burning properly.
STAINLESS STEEL
•
All stainless steel body parts should be wiped regularly with hot soapy water during the day and with
a liquid cleaner designed for this material at the end of each day. Do not use steel wool, abrasive
cloths, cleansers, or powders to clean stainless steel surfaces. If it is necessary to scrape stainless
steel to remove encrusted materials, soak in hot water to loosen the material, then use a nylon or
wood scraper to loosen debris. Never use a spatula, knife or any other metal tool to scrape stainless
steel. These tools will scratch the stainless steel.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Burner flame to large.
Incorrect pressure setting or
orifice.
Check pressure setting and orifice.
Burner flame soft and yellow
tipping.
Insufficient primary air.
Check air shutter setting.
Flame lifts off burner ports
Excessive primary air.
Check air shutter setting.
Flame lights back to orifice
Excessive primary air
Check air shutter setting.
Delayed ignition
1) Pilot flame too small.
2) Burner ports blocked.
3) Incorrect air shutter setting.
4) Incorrect pressure setting.
5) Pilot lighter tube dirty or
blocked.
1)
Check pilot flame length.
2)
Clean burner ports.
3)
Check air shutter setting.
4)
Check pressure setting.
5)
Clean tube.
Pilot burner will not ignite
1)Pilot blocked or dirty.
2)Pilot adjusting screw closed.
1)Clean pilot.
2)Open & adjust flame length.
6
Summary of Contents for MGFCO-1S
Page 2: ......
