INITIAL START-UP
All THERMA-TEK appliances are adjusted and tested before leaving the factory. Adjustments and
calibrations may be necessary upon installation to meet local conditions, low gas characteristics, problems
caused by rough handling or vibration during shipping, and are to be performed only by qualified service
personnel. These adjustments are the responsibility of the customer and or dealer and are not covered by
our warranty.
Check all gas connections for leaks with a soapy water solution before lighting pilots.
Do Not use an open
flame to check for leaks.
Putting an open flame beside a new gas connection is extremely dangerous.
Before lighting any pilots, make sure that burner valves and thermostats are in the off position.
LIGHTING THE PILOTS
CAUTION: When lighting the pilots and checking for leaks, do not stand with you face close to the
combustion chamber.
•
The pilots can be accessed from the top of the unit through the top grate or wok top.
•
Make sure main burner valve is in the off position.
•
Make sure pilot adjust valve located on the manifold is open. It can be accessed through a hole in the
front panel.
•
Light the pilot and adjust flame to approximately ½”.
SHUTDOWN
•
Nightly shutdown: Turn burner valves to off position, pilots will remain lit.
•
Complete shutdown: Turn burner valves to off position. Turn main gas supply to range off.
OPERATING INSTRUCTIONS
BEFORE USE
All units are wiped clean with solvents at the factory to remove any visible signs of dirt, oil or grease
remaining from the manufacturing process.
Top
The Top grates should be removed and washed before use. With these removed it will be possible to remove
wire ties holding the burners in place for shipment.
OPERATING SUGGESTIONS
STOCK POTS
Burners are quickly lighted and require no preheating time.
5
Summary of Contents for MGFCO-1S
Page 2: ......
