1-800-533-7533
Quest
DRY
150 Installation, Operation and Maintenance Instructions
www.thermastor.com
quest
Asset Protection and IAQ Solutions
quest
FOR HVAC INSTALLER ONLY
5. DEH 3000 Digital Control Installation Instructions
5.1 Specifications
Part Number:
4026570
Model:
DEH 3000 Digital Control
Electrical:
24 VAC
Humidity Range:
10 – 95% RH
Humidity Accuracy:
+/- 5%
Output:
3 Amps 24 VAC
Relay Capacity:
5 Amps
Temp Range/Accuracy: 2%
Size:
4.95" wide x 4.19" high
5.2 Installation
This control panel must be installed in the conditioned space and in
accordance with all applicable codes and standards. Follow the instructions
below when installing and setting this control.
5.2A Install Instructions
1. Separate the front panel from the back panel by depressing the middle
sections of the top and bottom of the front panel.
2. Line the back panel up against the wall or flat surface onto which it is to
be mounted and drill in the appropriate mounting holes.
3. Insert the screws and tighten down so they extend approximately 1/8” from the back plate.
4. Align the back panel so that the control is level.
5. Tighten the screws to lock into position.
6. Make the electrical connections to the terminals on the
back panel as shown in the wiring diagram.
7. Reassemble the front to the back panel. Connect at the
top first, then at the bottom.
8. Test connections (see Section 2.6)
5.2B Wiring
WARNING: DO NOT ALLOW THE YELLOW LEAD FROM
THE Quest
DRY
150 TO CONTACT THE RED OR WHITE
LEADS FROM THE Quest
DRY
150 OR DAMAGE TO THE
TRANSFORMER WILL RESULT. UNPLUG Quest
DRY
150
BASE UNIT BEFORE WIRING CONTROL.
The installer must supply the wiring between the Quest
DRY
150 and the control panel. Be sure to safely
route the control wires to prevent damage during installation. Be careful not to cross the wires when
connecting the Quest
DRY
150 and the remote control panel or damage to the transformer may result.
The remote control of the Quest
DRY
150 is powered by a low voltage circuit (24 VAC) and must
NEVER
contact or be connected to a high voltage circuit. Some of the control wires leaving the Quest
DRY
150 may
not be used with certain control panels and should be left safely disconnected with wire nuts taped onto the
stripped ends. Be sure to consult the electrical schematic in this manual or on the front panel of the Quest
DRY
150 before making the control connections.
Control Part No. 4026570
FOR HVAC INSTALLER ONLY
