1-877-420-1330
Quest 185 Cool
Installation, Operation and Maintenance Instructions
7
www.QuestHydro.com
5.1 D Hanging Diagram
5.1 E Ducting
Supply Duct Kit (P/N 4028607)
A factory designed supply duct kit can be purchased to accept 10” ducting to both outlets of the Quest 185 Cool.
Contact your dealer or call 1-877-420-1330 to order or go to www.questhydro.com/product-category/accessories.
Return Duct Kit (P/N 4028610)
A factory designed return duct kit can be purchased to accept 12” ducting. Contact your dealer or call 1-877-420-1330
to order or go to www.questhydro.com/product-category/accessories.
5.2 Condenser Setup
5.2 A Location
• The condensing unit is designed to be installed outdoors in a space that is protected from extreme weather
(rain, wind, etc.). Do not place the condensing unit in direct sunlight.
• Place the condensing unit at least 1” above ground level.
• Place the condensing unit as close as possible to the dehumidifier to minimize the length of the connecting
lines. The maximum line set length is 50 feet.
• Ensure the mounting of the condensing unit can withstand strong winds and earthquakes when mounting
above ground level.
• The condensing unit may be mounted to a wall (with brackets) or placed on a roof.
• Mount the base of the condensing unit to a sturdy level pad (or bracket) using 3/8” (10mm) bolts.
• Avoid directing the discharge air at people.
• If used near a water source; be certain there is no chance the dehumidifier could fall into the water or get
splashed and that it meets NEC standards.
Bottom view of
unit and bracket
Bracket (4036668)
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
HU
M
ID
NO
RM
AL
D
RI
ER
OFF
ON
BEFORE TURNING ON UNIT:
1. CUT AND REMOVE ZIP TIE
2. PLUG HOLES USING
INCLUDED PLUGS
CO
M
FA
N
24V
DEHU
*
DMPR
CO
M
FA
N
24V
DEHU
*
DMPR
24V
AC
COMP FAN
HONEYWELL REMOTE HUMIDISTAT
WIRING DIAGRAM
QUEST DEH 3000R CONTROL
WIRING DIAGRAM
