therm-ic SUPERMAX+, Instructions For Use Manual

Page: 12 / 110

10
INSTRUCTIONS FOR USE / ENGLISH
Note:
Please be sure to observe the provided information
sheet as well!
Charging procedure:
Each Powerpack has an LED that shows the charge
status (see table).
LED Description
on charging
blinking
charging complete
(maintenance charging)
Important: First, connect the charger to the socket.
Attach both Powerpacks to the charging cable. The
switch must be at the "0" position. The charging
process begins automatically (the corresponding
LED turns on).
The Powerpacks are automatically monitored and
turned off by the integrated electronics, regardless
of the charge status. After successful charging
(max. 4.5 hours), the Powerpacks are automatically
switched to maintenance charging mode (the
corresponding LED will blink).
In case of an error, the charging process is
automatically stopped after 5.5 hours.
DESCRIPTION OF FUNCTIONS
The S Powerpacks have two operating
modes: POWER OFF - IN USE
These modes are clearly indicated on the status
display (red LED).
POWER OFF:
The level switch is set to level "0". The status
display (red LED) remains off. The Powerpack is
now completely switched off.
IN USE:
The Powerpack is supplying the connected Therm-ic
sole with power. Each Powerpack can be
individually set to one of three different heat levels.
The status display (red LED) turns on.