Thenow HSN-J15-Z, User Manual

Page: 17 / 26

１７
Wine Cabinet Installation Conditions
1. Place the wine cabinet in a properly ventilation location. Otherwise, heat exhausted by the cooling unit will
build up and it will not operate properly.
2. Equipment should install on horizontal ground or platform, tilt angle must not exceed one degrees, platform or
ground should be able to load-bearing unit weight;
3. To keep good ventilation and easy maintenance,requires that the wine cabinet grill can be flexibly
disassembled.
4.
Never install the unit in danger areas,such as strong magnetic,steam,dust,heating source,corrosion and
combustible gases etc.
5. Unobstructed airflow to and from the unit is critical to unit’s overall performance and lifespan, make sure there
is a minimum of 50mm(100mm is better) of horizontal clearance in every direction around the unit.
6. Before install the unit, foam tape needs to be placed in the bottom and side of the unit.
7. Working environment: Temperature 5
℃
-35
℃
， Humidity RH<80%
8. Recommend air duct: A- Heat-insulating phenolic board, thickness 15~20mm
B- Stainless steel duct, 20mm insulation
9. If the back of the wine cabinet is close to the wall,and there is no space to reserve vents. Please make sure
left intake air vents at the two sides of the condensing intake air, and the larger the better. Meantime, keep at
least 100mm of horizontal clearance in every direction around the unit.
10. To better control the wet-film water inlet flow rate, electromagnetic water valve and ball valve are suggested
to be installed. Otherwise, the water will always be supplied to the machine in a normally open state, which will
cause the equipment to leak and fail to operate. （ HSN-J15-Z ）
The reference range of valve adjustment opening under the standard pressure of J15-Z is as follows:
Note: Make sure the smooth drainage too.
In order to avoid fire or electric shock hazard, please do not
expose the equipment to damp environment.
Model HSN-J15-Z
Valve Opening 1/4