Themis RES-32XR3-S, Installation Manual

Page: 67 / 146

2-19
Themis Computer
Installation and Operation
Operation
2. On the front of the RES-32XR3-S for X8DTL-6/6F push the system power
on/off button (see
Figure 2-15 ). This will cause the system
POWER
LED to
light (green).
2.3.3 Getting Started
2.3.3.1 Configuration
1. Make sure all storage drives are installed (see “SAS/SATA Storage Drive”,
page 2-9). Drive ID numbers are shown in
Figure 2-9 on page 2-10. Changes
may be made through the BIOS.
2. Connect a multiscan monitor to the VGA connector.
3. Attach a PS/2 keyboard and mouse to the appropriate connectors on the rear
I/O panel of the RES-32XR3-S for X8DTL-6/6F (see
Figure 1-5 on page 1-9)
4. Turn the system on (see previous section).
2.3.3.2 Linux Installation
The subject of installing the Linux operating system onto the RES-32XR3-S for
X8DTL-6/6F is detailed in Appendix C, “Red Hat Enterprise Linux 5 Installation”.
Figure 2-15.
Power Button and LED on the RES-32XR3-S for X8DTL-6/6F Front
System Power
On/Off Button
Power LED