1.
Inserting a new fleece roll
If the fleece roll is replaced, it must be taken care, that the
0-rings at the left and right side of the new roll are mounted
in the right way. They prevent, that the roll is turning freely.
This keeps the fleece always taut.
The inlet piping is secured with a clip. To change the roll,
loosen it and remove the complete inlet piping. Take care
not to get stuck at the level switch.
1.
Clip
2.
2. Gear wheel.
The new roll is now inserted.
The fleece is directed from the
new roll downwards. Hold the
end of the fleece tight while
remounting the inlet pipe. This
presses the fleece to the
bottom towards the grid. If the
inlet pipes are in the right
position, you can close the clip.
Now you can tear the fresh end
of the fleece and wind it round
the receiving roll. You can use a
piece of tape to fix it there. The
receiving roll is now pressed
into its place so that the gear
wheel of the roll and the gear
wheel of the motor match.
The connection cable can be
pushed into the transformer and
secured with the nut. The
direction of the poles does not
matter. If the transformer is
connected to the mains, you can
press and hold the switch at the
electronic compartment to start
the motor and the fleece is
pulled taut. Now the Rollermat
Compact I is ready to start.
