75
DHCP Server Configuration(For the N8900)
A DHCP server can be configured to assign IP addresses to devices connected to the
LAN
3
port. To configure these ports, choose Additional LAN3 Configuration from
the System Network menu.
DHCP Configuration
Item
Description
DHCP Server
Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN
3
interface.
Lowest IP in Range
Specifies the starting IP address of the DHCP range.
Highest IP in Range
Specifies the ending IP address of the DHCP range.
DNS Server
Displayed the DNS server IP address.
Storage Management
The Storage menu displays the status of storage devices installed in the Thecus IP
storage, and includes storage configuration options such as RAID and disk settings,
folder configuration, space allocation and ISO Mount.
Disks Information
From the Storage menu, choose the Disks item and the Disks Information
screen appears. From here, you can see various items about installed SATA hard
disks. Blank lines indicate that a SATA hard disk is not currently installed in that
particular disk slot.
NOTE
• The screen shot below just example from Thecus IP Storage. The disk
slots can from 4 to 8 depend on the model of Thecus IP storage.
NOTE
Before enabling Jumbo Frame Support, please make sure your network equipment
supports Jumbo Frame. If your equipment is incompatible, you might not be able to
connect to your Thecus IP storage.
NOTE
The IP Segment of WAN/LAN1, LAN2 and LAN3 should not overlap.
WARNING
The IP address of the LAN3 interface should not be in the range of the
Start IP address and End IP address.
NOTE
If the IP sharing mode setting is set to “Enable” under WAN/LAN1 port, then this 2
nd
gateway cannot be configured.