57
57
GB
The unit always reacts fully automatically in test operation.
Constant light control mode is not possible in test operation,
i.e. after switching on, the lights will always dim 100 %.
● If the value sent is too small, the LED will blink briefly (error blinking), if
the value is too large, the LED will flicker for one second.
● A value which makes the detector flicker
straight away rather than show the error
blinking, (e.g. 4.1) must be entered in
the settings window on the ETS as the
brightness value. This value is now the
detector’s new desired value.
● The desired value found in this way should take into account reflection and
influences such as furniture, installation location, incidence of light, etc.
6. Test Operation
Test operation is used to check the presence detection and connections
(parallel switching master-slave, master-master).
●
Set the detector to “Test Operation” using the management remote
control „Sendo Pro 868 A service or ETS (for parallel switching, set all
detectors to “Test Operation).
Summary of Contents for 201 9 290
Page 21: ......