P.10
Radio
16
Plug in with red+ / black- reversed will damage the ESC.
Battery Tie 180mm
Brushless ESC
Motor
Receiver
Battery
Motor
ESC
ESC
Brushless ESC
Brushless ESC
180mm Y-Cord
EZ Power Y-Cord For Twin ESC
KW1210060
EZ Connector Puller
Plug in the Aileron Servos wire to channel 1
Plug in the Elevator Servo wire to channel 2
Plug in the ESC Throttle wire to channel 3
Plug in the Rudder Servo wire to channel 4
1
2
3
4
5
6
ID
SET
Aileron Servo (L)
180mm Y-Cord
Aileron Servo (R)
Rudder Servo
Receiver
Elevator Servo
ESC
Battery Mat
Battery
Receiver
8x4E Propeller PL6210804
8x4P Propeller PL6210804P
Pilot View
8x4E prop. should be on the
left wing, rotating clockwise. 8x4P
prop. should be on the right wing,
rotating counter-clockwise. If you
are using the 3-pin EZ connectors,
unplug, rotate 180º and plug back
will reverse rotating direction of
the motor. For other plugs, inter-
change any two of the three motor
wires connection will reverse the
rotating direction. Never reverse
the battery connection to the ESC,
they must be red to red (+) and
black to black ( - ) or the ESC will
be damaged.
Connect the three motor wires of the left motor to the left ESC, and right motor to the right ESC.
Connect the throttle control wires of the two ESCs to the Y-chord. The single output plug of the
Y-chord should be connected to the throttle channel of the receiver to control the throttle. Connect
the power input plugs of the two ESCs to the EZ Power Y-Chord, the single output plug of the EZ
Power Y-Chord should be connected to the battery before flying. ( The same procedure applies to
other types of connectors. )
GM070XMPO30681411
