14
TSL.960
MANUAL
+
Connect the water supply (turn isolation valve on)
+
Turn power supply on and wait 20 seconds
+
Activate the sensor by placing hand within detection range, and water will flow.
commissioning
operation
Adjusting the sensor range:
The sensor range can be adjusted if required to suit the installation conditions.
1.
Disconnect the power supply (battery or mains).
2.
Wait a few seconds and reconnect the power supply.
3.
Position your hand less than 5cm in front of the sensor whilst the LED flashes.
4.
When the LED is contiuously lit (and no longer flashing), position your hand at
the new detection distance.
5.
Wait until the LED goes out before removing your hand.
6.
When the LED goes out the new detection distance will be set.
The user is to activate the tap by placing their hands within the range of the infra-red
sensor, to cause the solenoid valve to open for a preset time. The valve will close a set
time after the user’s hands have been removed from the detection range.
