Posi�on the base channel using a Set
Square. If using a raised shower tray,
leave a minimum 3mm gap from the
edge of the tray.
Insert the square alignment jig to
locate the wall channel. Using a spirit
level, ensure the wall channel is
ver�cal.
Mark the three pre-drilled holes.
Remove the channel.
Using a 6mm high quality drill bit for a
clean and precise hole, drill the three
marked areas, fully insert the wall plugs
and fix the channel.
1
2
3
4
IF NOT using a shower tray, posi�on the
base channel in the desired posi�on.
The end of the base channel should be
firmly against the wall where the wall
channel will be fi�ed to.
DO NOT fix the base channel to the tray
yet.
01/12
3mm minimum
Shower Tray
Professional Tip
If drilling ceramic tiles, place
masking tape on the tiles before
marking and drill through the
tape to prevent the drill bit from
skidding.
DO NOT use Hammer Action as
this will break the tiles.
No Gap
View 01
07/2019 V 2.2
