THE-ONE RS3, Instruction Manual For Use

Page: 51 / 68

8. Charging and protection
of the battery
Use the charger that corresponds to your e-Bike (never use the charger of a different model).
Before charging, set the switch to OFF and remove the key. Keep the charger in a dry and
ventilated place when not in use.
The charger is designed for internal use. Keep the charger far from water to avoid short circuit.
Do not use in humid and flammable environments. Do not remove the connector by pulling the
cable, always unplug the charger from its metal body.
Connect the charger output plug to the battery power socket correctly,
then insert the plug into the wall socket.
When the light changes from Red to Green it means the battery is fully charged. Usually a 4-6
hour time frame is required to fully recharge the battery. However, it is a good idea to recharge
the battery for an additional 2 hours to protect the battery life.
Do not charge the battery for more than 10 hours to avoid overcharging and damaging
the battery. After the light turns green, the charger will continue to charge the battery if not
unplugged. If you plan to stay away from home for a long time, disconnect the charger so as
to avoid overheating and overcharging.
The charger will become hot while charging, so keep it away from heat sources. Always keep
the charger clean and dry. The charger contains high-voltage electronics, therefore do not
disassemble the charger yourself.
After charging, first remove the plug from the electrical outlet and then from the e-Bike battery.
Do not leave the connector plugged into the battery and the outlet for a long time, as it may
damage the battery and/or cause a fire.
When charging, keep out of reach of children. Do not place anything above the charger during
use, do not allow any liquid or metal to enter the charger.