Installation & Operation Manual
4.2 Network
By default the network parameters are setup up using DHCP. In order to set static values, uncheck the DHCP check box
and enter new values in the address fields. If the values aren't changed the current addresses will be kept.
The TMPC
must be restarted for these changes to take affect.
Addresses in the Network section must be entered in Ipv4, dotted
quad, format.
4.2.1 IPv4 and IPv6
Both IPv4 and IPv6 are supported for static and DHCP setup. Set the parameters to match your network setup.The clock
generates a link local IPv6 address and will autoconfigure an IP address based on the router's subnet so no information
needs to be supplied, however if the user has a specific IP address the clock should use, it can be entered into the IPv6
input box.
4.2.2 DNS
If using fully qualified domain names for the time servers, then DNS entries must be included.
4.2.3 Mask HTTP Access on Subnet
Check this box to only allow setup of the TM1000A, through the web interface, from the local sunnet. This provides a
measure of security for the device from outside the subnet attack.
4.2.4 Mask NTP Access on Subnet
Check this box to only allow NTP access from the local subnet. Traffic originating from sources other than the local
subnet will be rejected.
4.2.5 MAC
The MAC address field is read only and only for information. It is needed for firmware updates.
4.2.6 SSID, Security Mode, and AP Password
These parameters are used exclusively by the WiFi network interface and must be set to match the Access Point (AP) that
the clock will use to synchronize its time. SSID is the name that the AP is referenced as and the AP Password is the
password associated with it. The Security Mode must also match the setup of the AP and is typically WPA1 or WPA2. The
“SSID” and “AP Password” fields must be filled even if operating in wired mode.
4.2.7 Channel and RSSI
Channel and RSSI are read only parameters for information about WiFi performance.
[ 5 ]
Time Machines by CSS | 6030 South 58th St., Suite C | Lincoln NE 68516
voice: 402.261.8688 | email: [email protected] | web: css-timemachines.com
