Installation & Operation Manual
1 Introduction
Time Machines Precision WiFi Clocks (TMPCs) provide an accurate synchronized time source when you absolutely can’t
afford a time shift. TMPCs use a power source and communicate with WiFi and Simple Network Time Protocol (SNTP) to
make installation and setup as clean and simple as possible. Connecting the clock to a WiFi enabled Network is all that is
needed.
CLOCKS:
- Digital WiFi Clock 2.5” x 4 Red Digits, Black Case
- Digital WiFi Clock 2.5” x 6 Red Digits, Black Case
- Digital WiFi Clock 2.5” x 4 Green Digits, Black Case
- Digital WiFi Clock 2.5” x 6 Green Digits, Black Case
- Digital WiFi Clock 4” x 4 Red Digits, Black Case
- Digital WiFi Clock 4” x 6 Red Digits, Black Case
- Digital WiFi Clock 4” x 4 Green Digits, Black Case
- Digital WiFi Clock 4” x 6 Green Digits, Black Case
OPTIONAL PRODUCTS:
- 2.5” Clock Rack Ear Set, Black
- 2.5” Dual Mount Bracket
- 4” 4-Digit Dual Mount Bracket
PART NUMBER:
760-240W-000
760-260W-000
760-242W-000
760-262W-000
760-440W-000
760-460W-000
760-442W-000
760-462W-000
PART NUMBER:
760-201-000
760-265-000
760-445-000
2 Initial Setup
2.1 WiFi Connection
The WiFi Clocks require a Wireless Network to be in place to function, as well as 110V power source. Alternately the clock
can be used on a wired network without the requirement of WiFi. Initial setup is all done with a web browser through the
wired connection.
2.2 Network
Beyond connecting to a WiFi network, nothing else is required to get TMPCs up and running. IP, Netmask, Gateway, and
DNS addresses are all setup using Dynamic Hosting Configuration Protocol (DHCP) by default. Static addresses may be
assigned by accessing the configuration web page. The default time server is set to
nist1-chi.ustiming.org
but can be
changed using the configuration web page. These processes are described with further detail in the Configuration section.
2.3 Mounting
TMPCs may be surface mounted, rack mounted, or in a dual mount bracket (using two clocks).
Required tools: hammer, drill, 1/4” drill bit, screwdriver and pencil. Mounting options are optional.
2.3.1 Surface Mounting to Drywall
1.
Mark the holes to be drilled based on the spacing of your specific clock. 12.5 inch centers for the 2.5 inch digit
clocks as well as the 4 inch by 4 clocks, and 16 inches for the 4 inch 6 digit clock.
2.
With a 1/4” drill bit, drill through the two marks.
[ 1 ]
Time Machines by CSS | 6030 South 58th St., Suite C | Lincoln NE 68516
voice: 402.261.8688 | email: [email protected] | web: css-timemachines.com
