Determine the desired height (low, middle, high) for the crib mattress. Fit each
support pin
into corresponding corner
as shown. Make sure support pin is securely engaged with assembly.
high
middle
low
3
4
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: (800) 933-9904 • e: [email protected] • www.landofnod.com
Taylor Crib
Assembly Instructions
Page 4 of 5
Made in Vietnam - r03
Fit pre-attached dowels of
side panels
and
crossbar
into corresponding holes of remaining
end panel
as shown. Using
a
small Allen wrench
, loosely attach bottom corners with 1
large bolt
, 1
spring washer,
1
flat washer
and 1
half-moon
bracket
per side panel as shown. Loosely attach
crossbar
to
end panel
with 1
large bolt
, 1
spring washer
, 1
flat washer
and 1
half-moon bracket
as shown. Using a
small Allen wrench
, loosely attach top corners with 1
small bolt
, 1
spring
washer
and 1
flat washer
per side panel as shown.
Do not fully tighten bolts until further instructions.
NOTE: Spring washers and
flat washers are pre-attached
to corresponding bolts
