Page 7
MAINTENANCE
Adjusting the Cutting Mechanism
Occasionally it may be necessary to adjust the cutting mechanism.
The distance between the cutting gear B and the cutting plate A should be between 0.50
and 1.00mm.
On the right hand side of the shredder ( looking from the back) there is an adjusting device.
Using the hex key supplied insert and turn clockwise half a turn (0.50mm) so that bolt C
moves toward the cutting plate (A).
After adjusting test the machine with varying thicknesses of material and re-adjust if
necessary. Bear in mind that the two cutting mechanisms should NOT touch.
Keep air vents clean and free from dust.
Use only a damp cloth to clean the machine and do not spray water on the shredder.
Detergents and solvents can cause irreparable damage and chemicals can destroy the
plastic housing.
Check the tightness of screws and bolts from time to time. A few drops of oil on the cutting
mechanism will help protect from corrosion.
Specification:
Model
THSS
Voltage
230V-50Hz
Rated Power
2500W
Operating Mode
S6 (40%) indicates a load profile of 4min load/6min idle
time
No-Load Speed
40rpm
Max Branch Diameter
40mm (depending on hardness of wood)
Weight
25kg
Sound Power Level
93dB(A) (K=3dB)
Sound Pressure Level
80dB(A)
Summary of Contents for THSS
Page 8: ...Page 8 PARTS DIAGRAM ...
