8
STEP 6: ADJUSTMENTS. When you have finished all of the above steps, if the hole at the
bottom of hopper cannot be closed and opened completely by using the handle you may
need to the follow these additional steps.
(1) Release the two bolts M5x10 on clamp as
shown. (2). Push the handle to the top position, use your hand to adjust the adjustable plate so
as to make sure the hole at the bottom of the hopper can be closed completely. (3). Push the
handle to the lowest position, use your hand to adjust the adjustable plate so as to make sure the
hole at the bottom of the hopper can be opened completely. (4). Tighten the bolts and nuts on
clamp.
To operate this spreader, push the handle to the lowest position (downwards). You may
move the position of the Wing nut on the Gauge & Lever to adjust the space on the hole
between the hopper and the adjustable plate as per your need when spreading.
Adjusting the position of this nut will
change the size of the hole between the
hopper and the adjustable plate.
Summary of Contents for THS80
Page 12: ...12 PARTS DRAWING ...
Page 15: ...15 ...