STEP 10
•
The three large holes at the bottom of the hopper should match the three holes in the adjustable plate. If
they match, do nothing.
•
If they do not match, push the handle down to the lowest position and adjust the positions of the two
nuts on the threaded control bar until the three holes match up. If the holes are not properly aligned, the
hopper will not close completely.
•
To operate the spreader, push the handle up to the top position. Adjust the wing nut as needed to
regulate the flow of material passing through the spreader.
•
Insert R-Pin
(17)
into the hole at the top of the Gearbox Spindle at the bottom of the Hopper as shown.
Make sure the impeller is turning in the right direction as indicated by the arrow.
•
Place Screen
(14)
into the Hopper.