Page 7
•
Pull Spring Pin (A) to remove Lock Pin (B).
•
Apply a thin coat of grease to both surfaces of the Control
Lever Guard as shown.
•
Insert Control Lever and Guard Assembly and ensure that
Bracket (C)
•
Lock the Control Lever and Guard Assembly down with
the Lock Pin (B) and Spring Pin (A).
•
Repeat on the other side.
•
Three positions are available for the Support Table for
different splitting lengths.
•
frame.
•
Insert the Support Table in the required brackets (E).
•
Turn the Lock Down Hooks (D) 90 degrees to secure
the table.
to bleed the air out of the hydraulic system
The cover of the oil tank should be loosened until air can
move in
tank filler should be detectable during operation.
Failure to do this will keep the sealed air compressed in
the hydraulic system and continuous air compression
and decompression will blow the seals of the hydraulic
system and cause permanent damage.
Before moving the log splitter, make sure the oil tank cap is
tightened to avoid any leakage. There are two wheels to
facilitate moving. If using a crane to move the machine, lay
the
hoist around the housing, never the handle.
ASSEMBLY, cont’d
A
B
C
Grease
D
E
A