The Handy THLS-6-PLUS, Operators Manual & Partslist

Page: 14 / 24

RAM ADJUSTMENT

The Handy Log Splitters are fitted with a Ram Adjustment Knob which reduces any unnecessary
movement of the ram, allowing for quicker and more efficient use of the tool.

Warning: When adjusting the ram movement do not put your hands between the hand knob
and the log splitter, as accidental release of the Control Handle would cause the returning hand
knob and handle to trap and crush your hand against the splitter.

To adjust the ram movement, first undo the hand knob.

Then without a log on the work table depress the Control Handle and the start button.

When the gap between the ram and the splitting wedge is the intended size, release the start
button, but continue to hold the Control Handle to keep the ram in place.

Slide the hand knob along the pipe to set the gap size. The closer you move the Ram Adjustment
Knob towards the Log Splitter, and the more you slide it down the pipe, the smaller the gap will
be left between the ram and the splitting wedge.

If the gap is correct you should place the hand knob against the log splitter.

If the gap is too small you can leave an equivalent space between the knob and the log splitter
so that the ram returns further back.

If the gap is too small you will have to press the start button to reduce it before setting the Ram
Adjustment Knob.

Once you have set the hand knob at the desired
position, retighten it to adjust the movement of the
ram.

Make sure that your hand is clear of the hand knob
area. You can now release the Control Handle. The
ram should now return to the desired position
whenever you release the start button and Control
Handle. You can repeat these steps if further
adjustment is required.
Ram
Adjustment
Knob