Cutting Grass.
Simply put the tool at the chosen height and allow the tool to glide above the lawn to achieve the same cutting
length of the grass.
Best performance can be achieved when the lawn is dry.
Trimming Hedges
The tool can be used to trim small hedges and shrubs. Hold the tool slightly tilted in relation to the hedge you
want to cut. First cut the side s from the bottom up, then cut the top.
When not in use, always put on the protective blades cover on both blades.
The run time for each blade are - Hedge Shear up to 45mins, Grass Shear up to 25mins. These figures can vary
depending on the tool’s usage etc.
When you notice a drop in cutting performance, recharge the tool immediately so that the battery does not
become fully discharged.
It is prohibited to remove or bridge any of the switching elements installed on the tool by the manufacturer
as this would prevent the tool from switching off automatically and result in high risk of injury.
MAINTENANCE & CLEANING
To achieve good results, you should always keep the blades sharp. We recommend that you immediately level
off any snags or ridges caused by stones or similar. The tool should be thoroughly cleaned both before and
after use. A few drops of oil (e.g. sewing machine oil) will improve the cutting performance of the blades, but
never apply any grease to the blades. To ensure constant exact cutting it is also important to remove grass
remnants and dirt from between the upper and lower blades.
Never clean the tool under running water
–
and particularly never with high pressure - because of the
potential danger to persons and property. Keep your cordless grass cutter combination in a dry and frost-
proof place and out of reach of children.
Note:
When storing the machine for longer than 6 weeks:
• Fully discharge the battery (by running the product)
and then recharge the battery for 3-5 hours.
• Store in a dry and frost
-free place.
• Recharge the battery every 1 or 2 months during the
winter, because the battery will discharge slowly.
SERVICE HINTS
Store the machine. Operating instructions and where necessary the accessories in the original packaging.
In this way you will always have all the information and parts ready to hand.
Please observe the following directions for the disposal of your accumulator/battery.
Batteries are not to be put into the rubbish. As a consumer you are legally obliged to return used batteries
and accumulators. At the end of the duration of your tool, the batteries or accumulators must be taken from
the apparatus, disposing of them separately. You have the possibility of delivering your old batteries and
accumulators to the local collecting points of your municipality or to your dealer or to the distribution
centers.
Summary of Contents for THGSS
Page 14: ...PARTS DIAGRAM THGSS 1938195001 ...
Page 19: ......
