6.
Ensure all parts are seated correctly & hold the chain and guide bar in a level position.
7.
Pull the guide bar away from the machine, ensuring the chain is tight and positioned in the guide bar
groove.
8.
Fit the cover plate; ensure the chain catcher fits into the groove of the cover plate.
9.
Press the cover plate firmly onto the machine and screw on the cover plate, with the locking knob.
CAUTION
The chain is not yet tensioned; do not attempt to use the machine, until the assembly instructions are
completed thoroughly.
CHAIN TENSION
Always check the chain tension before use, after the first cuts and regularly during use, approx. every 10
minutes. Upon initial operation, new chains can lengthen considerably.
WARNING
Unplug the chainsaw from the power source before adjusting the chain tension
WARNING
Cutting edges on the chain are extremely sharp. Always use protective gloves when handling the chain.
WARNING
Always maintain proper chain tension.
A loose chain will increase the risk of kickback.
A loose chain, may jump out of the guide bar groove, which may injure the operator and damage the chain,
chain bar and drive sprocket, beyond repair.
CAUTION
The life of a saw chain will rely on sufficient lubrication and correct tensioning.
Avoid tensioning the chain if it is hot. This will cause the chain to be over tensioned, when it cools down.
1.
Place the chainsaw on a flat, solid surface.
2.
Rotate the locking knob/chain tensioning knob clockwise, until the locking knob is screwed tightly. The
correct chain tension will be reached automatically. The ratchet mechanism prevents the chain tension
from loosening.
3.
The correct chain tension is reached when the chain can be raised 3-6mm from the centre of the chain
bar. This should be done, by using one hand to raise the chain against the weight of the machine.
4.
If the chain loses tension, unscrew the locking knob/chain tensioning knob completely. Then screw on the
cover plate with the locking knob tightly again.
