The Handy 1938182001, Instruction Manual

Page: 18 / 28

TROUBLE SHOOTING
PROBLEM PROBABLE CAUSE REMEDY SUGGESTED
Fails to split logs
Log is improperly positioned
Refer to “Operation” section for perfect
log loading.
The sizes or hardness of the log
exceeds the capacity of the
machine
Reduce the log sizes before splitting it on
the log splitter.
Wedge cutting edge is blunt
Refer to “Sharpening Wedge” section to
sharpen the cutting edge.
Oil leaks Locate leak(s) and contact the dealer.
The log pusher moves
jerkily, taking
Unfamiliar noise or
vibrating a lot
Lack of hydraulic oil and
excessive air in the hydraulic
system.
Check oil level for possible oil refilling.
Contact an approved service dealer.
Excessive air in the hydraulic
system.
Remove the Oil Filler/Air Bleed. Operate
the ram 5 or 6 times without a log in place.
Return the Oil Filler/Air Bleed and leave in
the open position and split the log. If the
problem continues contact the local
approved service dealer.
Oil leaks around
cylinder ram or from
other points
Air sealed in hydraulic system while
operating
Loosen Bleed Screw by 3 ~ 4 rotations
before operating the log splitter.
Oil Filler/Air Bleed is not tightened
before moving the log splitter.
Tighten the oil filler up before moving the
log splitter.
Hydraulic Control Valve
Assembly and / or seal(s) worn
Contact an approved service dealer.
Motor running, ram not
moving
Extension lead being used
Be sure the extension lead is no longer
than 10m and its cross-section is no less
than 2.5mm² to allow enough current flow
to the motor.
MAINTENANCE & STORAGE
Always ensure the Bleed Screw is fully tightened when the machine is not in use.
When not in use, the machine should be stored in a dry location. Keep the machine away from children and
others not qualified to use it. Avoid direct sunlight.
Do not store anything above or near the machine, where anyone might stand on the machine to reach them.