6
To Use
Press on the top of the belt clip to open; slide it
onto waistband or belt and release.
Or, lift the tip of the stand
away from the unit,
and set the unit on
any flat surface.
TIP:
Belt clip/stand
can be removed from
the Parent Unit to give
you a smaller unit that is
easy to slip in your pocket.
Belt Clip/Stand
You may connect a headphone (not supplied) to
the Parent Unit, if desired. When headphone is
used, sound will not come out of the speaker.
Finder Feature
If you should misplace the Parent Unit, turn off the
Child Unit. Wait 5 seconds, and the Parent Unit will
begin to beep and will continue beeping until it is
found and turned off (or batteries are exhausted).
Turn Child Unit on before turning the Parent Unit
back on.
Note:
This feature will not work if Parent Unit is
turned off or has lost power.
4
1
1. Press and release the power button on the
Child unit to turn it on and wait for the
connection indicator to blink.
2. Press and release the power button on the
Parent Unit to turn it on.
3. Be certain that Power and Connection
Indicators on both units are glowing blue.
4. For A200, perform steps 2 and 3 to turn on the
second Parent Unit.
5. On the Parent Unit, press + and/or - to adjust
volume to the desired level.
6. Keep the Parent Unit within hearing distance.
TIP:
A loud screeching sound will occur if Parent
Unit at a high volume level is brought close to the
Child Unit. This is feedback that is common with
audio devices. To avoid this it is best to either
lower the volume or shut off the Parent Unit when
entering the Child's room .
To turn Parent Unit off:
Press and release power
button.
To turn Child Unit off:
Press and release
power button.
Note:
Turning units off conserves battery power.
Important:
Power indicator on the Parent Unit
will turn red when battery power is low. Batteries
should be replaced as soon as possible. Follow
instructions under “To Set Up.” [Page 5]
Range
The distance you can separate the units and still
maintain a connection will vary based on the layout
and construction of your home. To test the
Monitor’s workable range, walk through your
house and yard listening for the volume and clarity
of the sounds being transmitted.
Out of range warning:
If the Parent Unit is taken
to a location where the connection with the Child
Unit is lost, the Connection Indicator will
flash
and the unit will
beep
after 5 seconds. This
warning will stop when unit is brought back
into range.
3
2
2
Parent unit
Child unit
Headphone Use
4
4
3
2
2
1
1
1
1
