57
6.14 PTZ Setup
There is one RS-485 port on the DVR rear panel used for PTZ control.
6.14.1 PTZ RS485 Connection
Connect DVR/DVS RS-485 port Pin “T+” with PTZ Pin “A”. Connect DVR RS-485
port Pin “T-“ with PTZ Pin “B”. If DVR RS-485 port is an RJ45 interface, please
refer to DVR user manual for the RS-485 pin definition.
6.14.2 PTZ Settings
Configure the RS-485 parameters to match your PTZ protocol. In the main menu,
select the PTZ setup option.
PTZ menu Options:
•
Select channel:
Select a PTZ camera.
•
RS-485 parameters:
Including baud rate, data bit, stop bit, parity, flow control, etc.
These parameters must be the same as those required by the PTZ protocol.
•
PTZ address:
Each PTZ has a different address.
•
PTZ type:
The DVR has the following PTZ protocols:
YouLi, LinLin-1016, LinLin-820, Pelco-p, DM DynaColor,
HD600,
JC-4116,
Pelco-d WX,
Pelco-D,
VCOM VC-2000,
NetStreamer,
SAE/YAAN, Samsung,
Kalatel-312, CELOTEX,
TLPelco-p, TLHHX-2000, BBV,
RM110,
KC3360S,
ACES,
ALSON,
INV3609HD, Howell,
Tc Pelco P,
Tc Pelco D, AUTO-M,
AUTO-H,
ANTEN,
CHANGLIN,
DeltaDome, XYM-12,
ADR8060,
EVI-D30,
DEMO-SPEED,
DM-PELCO-D ST832,
LC-D2104,
HUNTER,
A01,
TECHYIN, WEIHAN,
LG,
D-MAX,
Panasonic,
KTD-348, infinova,
PIH-7625,
LCU,
DennarDome,
VICON,
TKC676,
YAAN_NEW
DL_NVS_1Z, i3DVR.
Other PTZ protocols will be added with the new firmware.
Note:
If you select Pelco-P protocol set the dome address one number higher than the
DVR setting. For example, if camera ID is 2, the DVR PTZ address is set as ID 3.
