20
USER’S GUIDE
20
USER’S GUIDE
15
USER’S GUIDE
20
Never leave the H2O MOP X5™ unattended while plugged in.
For Best Results:
1)
Sweep or vacuum floor prior to using the H2O MOP X5™.
2)
To avoid puddling of water, the Microfiber Cloth must
be clean and dry for use. To replace the cleaning cloth,
proceed as follows: Let the cleaning cloth cool down,
remove cloth from unit, replace with a new Microfiber Cloth
(Optional Item) and continue use. Select low steam regulator
position.
3)
To sanitize an area of your floor, leave the H2O MOP X5™
at high steam setting over the steam area for about 10 seconds,
but no longer than 15 seconds.
Do not carry out this procedure on heat and steam
sensitive floors.
• Never steam at one spot for too long. This can cause floor
surface damage.
• Do not put hands or feet under the steam mop. Unit gets very hot.
• During use a pulsing noise may be heard indicating that the mop is producing
steam. This noise is normal.
• There may be some minor “spitting” of water mixed with the steam. This is
also normal.
• The force and heat of the steam may adversely affect certain materials. Always
check the suitability of using the steam mop on a surface by carrying out a
preliminary test on a hidden area.
Thane Direct and its affiliated companies assume no liability for personal injury or
property damage resulting from the misuse of the H2O MOP X5™, including the
failure to comply with the instructions contained in this User Guide or provided by
the manufacturer or distributor of the treated surface.
!
NOTICE
!
IMPORTANT
!
WARNING
!
Make sure that the H2O MOP X5™ is unplugged.
1)
Fill the Water Tank with water. Please refer to the “HOW
TO USE THE H2O MOP X5™” section in this manual.
Attach either the round nylon brush or the round copper brush as
explained in the “How to assemble Hand-Held Steamer” section in
this manual.
2)
Select one of the following Steam Regulator positions:
1 – Low, 2 – Medium, 3 – High or 4 – Hot Spray.
You can change the Steam Regulator position and
the steam output while operating the H2O MOP X5™.
3)
Once the unit has been fully assembled and filled with water, plug in
the Power Cord into a grounded electrical outlet.
RED light - Power Indicator will indicate when power is on.
Power Switch ( O / I ) is in the OFF ( O ) position (higher position).
Wait for the Ready-to-Use indicator to turn Green - approximately 20 - 30 seconds.
GREEN light will turn on when the steam mop is ready for use.
When the Ready-to-Use indicator light turns green press the Power Switch ( O / I )
to the ON ( I ) position (lower position).
The Hand-Held Steamer will start
emitting steam.
To stop emitting steam, turn OFF the
unit by pressing the Power Switch ( O / I )
again. If the Power Switch ( O / I ) is
pressed (lower position) prior to the
Ready-to-Use light indicator turning
green, water from previous use will
not be heated and will be forced out
by present steam.
HOW TO USE HAND-HELD STEAMER
ON (I)
Position
(Lower)
OFF (O)
Position
(Higher)
Red - Power ON
Green - Ready to use
CAUTION
