Chapter 2: SafeNet ProtectServer Network HSM Plus Hardware Installation
6.
If you have already installed SafeNet ProtectToolkit client software, refer to the
SafeNet ProtectToolkit-C
Administration Guide
.
Smart Card Reader Installation
The unit supports the use of smart cards with a SafeNet-supplied smart card reader. Other smart card readers
are not supported.
The SafeNet ProtectServer Network HSM Plus supports two different card readers:
>
the new USB card reader (introduced in 5.2)
>
the legacy card reader, which provides a serial interface for data (via a USB-to-serial cable) and a PS/2
interface for power (direct or via a PS/2 to USB adapter)
Installing the USB smart card reader
To install the USB card reader, simply plug the card reader into the HSM USB port on the back of the device, as
illustrated below.
Installing the legacy card reader
To install the smart card reader, connect it to the HSM USB port with the included USB-to-serial cable.
The legacy card reader must also be connected to a PS/2 port for its power. Many newer servers have USB
ports, but do not provide a PS/2 connection.
If there is no available PS/2 connection, there are two options:
>
Connect a PS/2-to-USB adapter between the card reader and a USB port on the SafeNet ProtectServer
Network HSM Plus.
>
If, for security reasons, you prefer to not expose USB ports on your crypto server, connect a PS/2-to-USB
adapter cable between the card reader and a standalone powered USB hub.
NOTE
The USB connection is for power only. No data transfer occurs over this connection.
SafeNet ProtectToolkit 5.8 Installation and Configuration Guide
007-013682-006 Rev. A 08 January 2020 Copyright 2009-2020 Gemalto
21
