TH COMMUNICATIONS MotionProtect Outdoor, User Manual, Page: 9 / 16

TH COMMUNICATION SDN BHD www.thcomm.com.my info@thcomm.com.my
Arm in night mode
If active, the detector will switch to armed mode when using
night mode
Alert with a siren if motion
detected If active, HomeSiren and StreetSiren are activated when the
motion detected
Signal Strength Test Switches the detector to the signal strength test mode
Detection Zone Test
Switches the detector to the detection area test:

General motion detector test

Upper motion detector test

Lower motion detector test

Masking sensor test
Attenuation test
Switches the detector to the signal fade test mode (available in
detectors with firmware version 3.50 and later)
User Guide Opens the detector User Guide
Unpair Device Disconnects the detector from the hub and deletes its settings
Indication
MotionProtect Outdoor light indicator may light up red or green depending on the device status.
Indication When Pressing the “On” button
Event Indication
Pressing the power button (detector is switched
on)
Lights up red while the button is held down
Switching on
Lights up green while the device is switching
on
Switching off Initially lights up red, then blinks three times
Turned-on detector indication
Event Indication Note
Detector
connection to the
hub
Lights up green for a few
seconds
Hardware error Blinks red continuously
The detector requires repair, please
contact Support Service