NBC™ Flat Belt - IOM
P/N: 1118140
Rev: 07/29/2020
Page
109
of
129
Disassembly/assembly procedure as follows
1. Remove necessary guards to access maintenance areas.
2. Disconnect any electrical connection.
3. Remove gearmotor.
4. Perform required maintenance.
5. Reverse procedures for assembly.
6. Replace all guards.
Regularly inspect all gearmotors to guarantee maximum performance.
1. Tightness of bolts and screws.
2. No major oil leaks.
3. No excessive heating.
4. No unusual vibration or noise.
Do not perform maintenance on the conveyor until the startup controls are
locked out and cannot be turned on by any person other than the one
performing the maintenance.
If more than, one member of a crew is working on the conveyor, EACH
CREW MEMBER MUST HAVE A LOCK ON THE POWER LOCK OUT.
The air pressure must be turned off to the work area.
All pneumatic devices must be de-energized to prevent accidental cycling of
the device.
Solenoid Valves
In order to minimize downtime, it is normally not feasible to repair malfunctioning electrical or valve
components while leaving the conveyor unusable. Spare components should be kept in stock for
emergency replacement. If feasible, the part may be repaired later to replace maintenance stock.
Items which cannot be readily repaired or are questionable should be replaced. Components under
warranty should not be repaired except in an emergency.
Before removing a valve or other pneumatic component, shut off and
exhaust the entire pneumatic circuit and shut off and lockout electrical
supply.
WARNING
WARNING