WARNING:
AC power must be off before proceeding with assembly or installation of emergency driver.
IMPORTANT:
For use with non-dimming LED fixtures up to 12W. For use with LED fixtures(MAX 100W)
that utilize 0-10V dimming that are above 12W, but this inverter will be limited to 12W(Including driver).
IMPORTANT:
An un-switched AC power source of 100Vac to 347Vac is required.
CAUTION:
Make sure all electrical connections conform to the National Electrical Code and all
applicable local regulations.
CAUTION:
Do not let power supply cords touch hot surfaces.
CAUTION:
Do not mount near gas or electric heaters.
CAUTION:
Use with grounded, UL Listed, dry location rated fixtures.
CAUTION:
The equipment is intended for ordinary locations and for permanent installation into one or
more Listed emergency luminaires.
CAUTION:
Battery is rechargeable Li-ion type and must be recycled or disposed of properly.
Do not use this emergency driver with accessory equipment other than recommended by manufacturer;
failure to follow this may cause an unsafe condition. Servicing should only be performed by qualified
service personnel. Do not use this emergency driver for other than intended use. Not suitable for high-risk
task area lighting. Equipment should be mounted in locations and at heights where it will not readily be
subjected to tampering by unauthorized personnel.
IMPORTANT:
Indicator (LED light) illuminated indicates battery in charge mode when AC power is
applied. It is recommended and required by applicable code to test emergency LED Driver to ensure
proper function of the system; push the test switch every thirty (30) days to ensure the emergency driver
is functioning by illuminating the light source. Conduct a ninety (90) minutes discharge test one (1) time
per year; LED light source should be illuminated for a minimum of ninety (90) minutes .
TESTING SYSTEM:
The emergency battery requires a charge minimum of one (1) hour before testing
the circuit. A full charge requires twenty four (24 Hours) .
Risk
of
Electric
Shock
SAVE THESE INSTRUCTIONS
PLEASE READ CAREFULLY AND FOLLOW ALL
INSTRUCTIONS FOR YOUR OWN SAFETY
When using electrical equipment and this lighting device
basic safety precaution should be followed at all times
including but not limited to the following:
IMPORTANT SAFEGUARDS
Disconnect power at fuse or
circuit breaker before installing
or servicing
Installation And Operation Instructions
WP-CEP-12C-200VPE
Summary of Contents for WP-CEP-12C-200VPE
Page 4: ...Wiring Diagram and Dimensions ...
Page 5: ......
