7 System Schematic
8 Installation
8.1 Warning
Pls read this chapter carefully before installation. To make sure the whole process is safe .
It is important to choose the installation location for controller. Keep the controller away from rain, insolation , put the
controller in dry ,ventilated place .
Metal material placed around the controller is prohibited, if not. may cause battery short circuit .
There should be enough space around the controller for cooling .
This controller could only charge to the lead-acid batteries which are in control range of this controller .
Not fully connection and corrosive wire will produce lot of heat .Then wire insulation layer may be melted, lead surrounding
material combustion ,even fire. So please ensure every connection is secure , to avoid connector loose when moving.
8.2 Installation Steps
Step 1 : Select Location Do not install the controller in place where insolate, high temperature and rainy. Pls keep enough
free air around the controller .
Step 2: Inspect Put the controller on the place where it is easy to install and inspect if there is enough space for
connections.
Step 3 : Mark Mark with 4 dots on install surface through controller
’s 4 open holes.
Step 4 : Drill holes Drill 4 holes in the 4 dots which marked in setp 3 .
Step 5: Fix controller Aim controller
’s 4 open holes towards the 4 holes which were drilled in step 4. Then fix controller
with screw nails .
Step 6 : Check Make sure the controller is firmly installed .
12
PC
Battery
Wind Turbine
Solar Panel