2. MAINTENANCE INFORMATION TGB
2-4
Gear Oil
Inspection
Check gear oil if leaking.
Park the motorcycle with main stand on flat
level place.
Turn off engine and remove the gear oil
draining plug.
Place a measurement cup under the draining
hole.
Remove the oil drain plug and drain gear oil
into a measurement cup.
Check gear oil if enough.
Replacement
At first, remove the gear oil refilling bolt, and
then remove the draining plug.
Install the draining plug after drained oil out.
Torque value: 0.8~1.2 kgf-m
Caution
Fill out gear oil to specified quantity from the
engine oil filling hole.
Install the oil filling bolt.
Torque value: 0.8~1.2 kgf-m
Transmission oil capacity: 120 c.c.(110
c.c. for change)
Recommended: King-Mate HYPOID GEAR
OIL ( #140 ).
VALVE CLEARANCE ADJUSTMENT
Caution
Remove luggage box and front center cover.
Remove the left body cover & left side cover.
Remove cylinder head cap.
Remove the ignition timing check hole on the
cooling fan cover.
With “T” type wrench, turn crankshaft in
clockwise motion so that mark (“T”) on the
generator flywheel aligns with the mark on
the crankshaft, and camshaft is at TDC
position also as same as level of cylinder
head top-end. A single hole on camshaft
sprocket is forward to up. (Piston is at TDC
position in the compression stroke.)
Caution
Inspect if washer is in good condition.
Replace it with new one if it was
deformed or damaged.
Checks and adjustment must be performed
when engine is cold (below 35
℃
).
The crankshaft can not be rotated in
counter-clockwise to prevent from damage
so that valve clearance can not be
measured.
Ignition timing mark
TDC mark
Inspection hole
Gear oil refilling bolt
Gear oil draining plug
