5
5. Now fit the tiller to the mainframe (see fig 3). Working from the left side of the scooter, hold the tiller at the handlebar
with your left hand holding it upright but tilted back slightly, lift the frame with your right hand on the lever, and lower the
front of the frame over the block on the tiller, as fig 3. After the frame has dropped over the tiller location push the lever
forward and down until it locks. Make sure the connection is secure by moving the
tiller. The electrical connections are made automatically.
Fig
3
Fig 4
6. Fit the batteries by lowering them gently down into their locations at the rear of the scooter (see fig 4). Again the
electrical connections are made automatically.
7. Unfold the seat to its normal position by holding the backrest and pulling up and back (fig 5a). Continue pulling (5b)
until it reaches the driving position and you will hear a click as it locks into place. Make sure it has locked in by making
sure you hear the click, and by trying to push the back of the seat forward. You may find this stage easier by holding
the scooter still with your foot on the Buddy floor (fig 5c).
Fig 5a
Fig 5b
Fig 5c
8. Attach the rear basket by hooking it over the lugs
on the seat (fig 6). Do not overload the basket.
Maximum load 10 Kg.
9. Fit the arms by locating them on the seatback
uprights and tightening the bolts securely. After
installing make sure the arms will pivot.
10. Buddy should now be ready for use. Before doing
this however, please read this manual carefully
and fully understand it.
Fig 6
