11
(Fig.X)
Close the transport safety device
(14)
on the frame, in order to avoid
accidental unfolding. Tighten the band of the transport safety device if
necessary.
(
Fig
.XI)
Insert the rear wheels
(17)
in the rear axle. Make sure the wheels are
completely clicked into place! Finally, hang the brake cable
(15)
in the holding
fixture of the brake cylinder
(16)
and test by using the hand brake
(25)
. If you
would like to remove all of the wheels, disconnect the brake cable
(15)
, press the
button on the wheel hub
(17)
and pull off the wheel.
(Fig.XII)
Insert the front wheel
(20)
in the designated opening
(18)
until it audibly
clicks into place. In position
(19)
the front wheel
(20)
can move freely, and in
position
the front wheel
(19)
is immobile. When you press the grey button, you
can pull down and remove the wheel. Inside the wheel attachment you can find
two set screws to adjust for straight running when necessary.
(Fig.XIII)
The backrest can be continuously adjusted by pulling the strap. Push
both plastic pieces
(21)
on the backrest together and adjust the sitting
position with the strap. You can set the pushbar height by pushing and
swinging the two adjustment joints
(22)
simultaneously.
(Fig.XIV)
The hand brake
(25)
is a walking and parking brake at the same
time. To activate the parking brake, you must pull the brake lever
(25)
fully
tight and completely close the red parking lever
(24)
so that the brake lever
(25)
remains tightened to the maximum, and the brake is permanently
blocked. To release the brake, you must pull the brake lever
(25)
and unlock
the parking lever
(24)
again. If the braking effect starts to weaken, you can
carry out a fine adjustment. To do so, turn the adjusting screw
(23)
on the
brake grip counterclockwise and check the braking effect again.
Summary of Contents for Joggster velo
Page 1: ...1 Gebrauchsanleitung Operating Manual Video on www buggy de or scan QR Code ...
Page 2: ...2 ...
Page 14: ...14 ...
Page 15: ...15 ...